Continuous Waste Tyre Pyrolysis Plant
Pyrolysis Plant is used for recycling waste tire, waste plastic, waste rubber to fuel oil. According to the actual situation in every country and district, we developed different models of Batch Pyrolysis Plants for waste tires, rubber and plastic with daily capacity 25-40 tons.
Flowchat of Continuous Waste Tyre Pyrolysis Plant
Advantages of Continuous Waste Tyre Pyrolysis Plant
1. Large daily capacity of 25 MT raw materials, and can work 24 hours without any stop for 15-20 days;
2. Auto-loading, auto-discharging and oil coming out at the same time;
3. Only need fuel for the beginning 2-3 hours, then the sync gas generates itself is enough to support heating, saving fuel cost;
4. Low requirement on the raw materials, no need tiny granule, 5cm pieces acceptable for smooth running;
5. High efficiency condensers, more oil output, good quality oil, easy to clean.
6. Sync gas recycling system, fully burned after recycling and utilization, preventing pollution and saving fuel cost.
7. National patent smoke scrubber, can efficient remove the acid gas and dust of the smoke, environmental friendly to meet related national standards.
8. Easy to operate, need less manpower.
Technical Parameter of Continuous Waste Tyre Pyrolysis Plant
NO.
ITEM
Technical Parameter
1
Suitable Raw Materials
Small pieces of Waste tyre,rubber, waste plastic≤5cm
2
Operating Mode
Fully Continuous Operation
3
Structure
Horizontal Type Revolve
4
Loading and discharging
Fully Automatic Feeding and Discharging under High Temperature at Same Time
5
Capacity(24h)
8-20Mt
6
Work Pressure
Slightly Negative Pressure
7
Oil Yield of tyres
40%-45%
8
Reactor Rotational Speed
1R/M
9
Installation Power
110kw
10
Cooling Method
Cycle water
11
Type of Drive
Sprocket Wheel
12
Heating Method
Hot Air
13
Noise dB(A)
≤85
14
Main Reactor Weight (MT)
About 20Mt
15
Total Weight(MT)
About 45Mt
16
Installation Space Required
60m*20m
17
Manpower
2/shift
18
Shipment
5*40HC
19
Delivery time
≤70Days
Continuous Waste Tyre Pyrolysis Plant Continuous Pyrolysis ,Continuous Pyrolysis Plant,Continuous Waste Tyre Recycling,Waste Tyre To Oil Shangqiu Jinpeng Industrial Co., Ltd. , https://www.recyclingthewaste.com
A chlorite-monohydrate soft bauxite bauxite ore in foreign countries contains 41.93% Al 2 O 3 , 10.68% SiO 2 and 30.6% Fe 2 O 3 . After sieving and washing, the coarse grade (-50mm+3mm) is subjected to selective crushing and grading, the coarse fraction is low aluminum-silicon ratio product, and the fine grade (less than 0.4mm) can be used to remove impurity iron by selective flocculation. The process flow is shown in Figure 1b. The aluminum concentrate can be obtained with Al 2 O 3 52.3%, SiO 2 8.43%, Fe 2 O 3 8.43%, aluminum recovery rate 73.3%, aluminum-silicon ratio 6.2 sorting effect, see Table 1.
Table 1 鲕 chlorite - boehmite bauxite ore selection index 
鲕 chlorite-monohydrate soft bauxite bauxite technology
Characteristics of the fine ore is hematite and chamosite closely with a boehmite, a partially enriched boehmite bauxite is easily dissociated upon crushing, and fine iron minerals in the fine level The particles are dispersed.
product name
Yield/%
grade/%
Recovery rate/%
Aluminum to silicon ratio
Al 2 O 3
SiO 2
Fe 2 O 3
Al 2 O 3
SiO 2
Fe 2 O 3
Bauxite concentrate
Low aluminum to silicon ratio product
High magnesium product (flocculation overflow)
Raw ore
59.2
18.0
22.8
100.0
52.3
33.99
21.95
41.93
8.43
13.28
14.45
10.68
8.43
13.28
14.45
30.3
22.35
32.12
50.77
30.6
73.8
14.6
11.6
100.0
46.7
22.4
30.9
100.0
6.2
2.6
1.5
3.9
Figure 1 Flow chart of the selection process of boehmite bauxite
8a-a kaolinite; b-a chlorite